Ricon B156, Service Manual

Page: 666 / 781

BIT SWITCHES
B750 52 SM
System Switch 1E SP No. 1-101-031
No FUNCTION COMMENTS
0 Communication after the
Journal data storage area has
become full
0: Impossible
1: Possible
This setting is effective only when Automatic Journal
printout is enabled but the machine cannot print the
report (e.g., no paper).
0: If the buffer memory of the communication
records for the Journal has become full, fax
communications will become impossible, to prevent
overwriting the communication records before the
machine prints them out.
1: If the buffer memory of the communication
records for the Journal is full, fax communications
are still possible. But the machine will overwrite the
oldest communication records.
Cross Reference
Automatic Journal output - User switch 03 bit 7
Number of communication records for the
Journal:
200 records (standard)
1000 records (with the Function Upgrade unit
installed)
1 Action when the SAF memory
has become full during
scanning
0: The current page is erased.
1: The entire file is erased.
0: If the SAF memory becomes full during scanning,
the successfully scanned pages are transmitted.
1: If the SAF memory becomes full during scanning,
the file is erased and no pages are transmitted.
This bit switch is ignored for parallel memory
transmission.
2 RTI/CSI display priority
0: RTI 1: CSI This bit determines which identifier, RTI or CSI, is
displayed on the LCD while the machine is
communicating in G3 non-standard mode.
3 File No. printing
0 : Enabled
1 : Disabled
1: File numbers are not printed on any reports.
4 Action when authorized
reception is enabled but
authorized RTIs/CSIs are
not
yet programmed
0 : All fax reception is disabled
1 : Faxes can be received if the
sender has an RTI or CSI
If authorized reception is enabled but the user has
stored no acceptable sender RTIs or CSIs, the
machine will not be able to receive any fax
messages.
If the customer wishes to receive messages from
any sender that includes an RTI or CSI, and to block
messages from senders that do not include an RTI
or CSI, change this bit to “1”, then enable
Authorized Reception.
Otherwise, keep this bit at “0 (default setting)”.
5 Address display priority in the
AI redial mode
0: RTI/CSI
1: Telephone number
0: When the machine has both RTI/CSI and the
telephone number information, the machine displays
RTI/CSI.
1: The machine always displays the telephone
number.
6-7 Not used Do not change the settings