Ricon B156, Service Manual

Page: 244 / 781

SERVICE PROGRAM MODE
B156/B220 5-16 SM
2
Mode No.
(Class 1, 2, and 3)
Function / [ Setting ]
Dctr Roller Interval
1 Job_Interruption: K
2 Job_Interruption: M
3 Job_Interruption: C
4 Job_Interruption: Y
Specifies the timing for reversing the doctor roller during
the multiple printing with single color. When this counter
reaches the prescribed value, reversing the doctor roller
is done during the print job.
In addition, reversing the doctor roller is done when the
counter reaches the 1/2 prescribed value in these SPs
after the toner near end has been detected.
[0 ~ 200 /
100 / 10 /step]
0: Disables job interruption .
5 Job_end: K
6 Job_end: M
7 Job_end: C
980
8 Job_end: Y
Specifies the timing for reversing the doctor roller after
job end with single color. When this counter reaches the
prescribed value and next job is not commanded,
reversing the doctor roller is done after the job end.
[1 ~ 100 /
20 / 1 /step]
Toner Revitalization
1 Job_Interruption Specifies the number of prints for executing toner
revitalization in the middle of a job.
[0 ~ 200 /
100 / 10 /step]
0: Disables job interruption.
For A4 SEF, the counter counts twice
.
981
2 Job_ End Specifies the number of prints for executing toner
revitalization at the end of a job.
[0 ~ 100 /
20 / 1 /step]
0: Disables toner refresh at end of a job.
For A4 SEF, the counter counts twice.
Dev. Motor Control
1 Speed Shift Time Specifies the interval for changing the development
motor speed from half speed to normal speed.
[0 ~ 500 /
100 / 10 ms/step] DFU
982
2 Dev.CL_Off Time Specifies the interval until turning off the development
clutch after turning off the development motor.
[
−
150 ~ 0 /
−
60 / 10 ms/step] DFU