Ricoh M156, Service Manual

Page: 96 / 169

Service Program Mode
SM 5-9 M156/M157/M176/M177
S
er
vi
c
e T
ab
le
s
Engine Maintenance
Waste toner
disposal
Sets the machine operation at "waste toner full" of the refilled AIO.
[On or Off (Default)]

With main motor rotation count feature, machine can be set to
stop printing after print total exceeds a certain set value. If print
count exceeds this value, then "Replace Print Cartridge"
remains in display. Then a new AIO cartridge must be installed.
This feature is a safety measure to prevent the used toner tank
from becoming full (there is no toner overflow detection
mechanism).
1200DPI
Power
Adjusts print density (density levels by increasing the number)
[31 to 155 / 112 (Default) / 1 /step]
Refill Mode
Setting
Auto refill mode
Do not change this setting
(Designed for Factory Use).
Pure refill mode
Do not change this setting
(Designed for Factory Use).
Scan Maintenance
Mono
Compression
Sets the monochrome compression type for scanning.
MH (Default)/ MR/ MMR
Registration Adjust
ADF Main Reg.
Adjusts the ADF Scan main-scan registration.
[-2.0 to 2.0 / 0 (Default)/ 0.1 %/step]
ADF Sub Reg.
Adjusts the ADF Scan sub-scan registration.
[-2.0 to 2.0 / 0 (Default)/ 0.1 %/step]
Flatbed Main
Reg.
Adjusts the Flatbed Scan main-scan
registration.
[-2.0 to 2.0 / 0 (Default)/ 0.1 %/step]
Flatbed Sub Reg.
Adjusts the Flatbed Scan sub-scan registration.
[-2.0 to 2.0 / 0 (Default)/ 0.1 %/step]
Size Adjust ADF Main Reg.
Adjusts the ADF Scan main-scan magnification.
[-0.9 to 0.9 / 0 (Default)/ 0.1 %/step]