Ricoh LANIER MP 301SP, Service Manual

Page: 464 / 553

Bit Switches
D127/D128 5-12 SM Appendix
System Switch 09 [SP No. 1-101-010]
No FUNCTION COMMENTS
0
Confidential image option on
the result report
0: OFF
1: ON (Attached)
Selects images Attached/Not attached on the
accumulation/Tx result report for confidential Tx.
1
Condition selection for admin
communication report record
0: After image data Tx
1: After call connection
0: Communications that reached phase C
(message tx/rx) of the T.30 protocol are listed on
the Journal.
1: communications that reached phase A (call
setup) of T.30 protocol are listed on the Journal.
This will include telephone calls.
2
Automatic error report printout
0: Disabled 1: Enabled
0: Error reports will not be printed.
1: Error reports will be printed automatically after
failed communications.
3
Printing of the error code on
the error report
0: No 1: Yes
1: Error codes are printed on the error reports.
4 Not used Do not change this setting.
5
Power failure report
0: Disabled 1: Enabled
1: A power failure report will be automatically
printed after the power is switched on if a fax
message disappeared from the memory when the
power was turned off last.
6
Conditions for printing the
protocol dump list
0: Print for all communications
1: Print only when there is a
communication error
This switch becomes effective only when system
switch 00 bit 6 is set to 1.
1: Set this bit to 1 when you wish to print a protocol
dump list only for communications with errors.