Ricoh LANIER MP 301SP, Service Manual

Page: 424 / 553

Fax Error Codes
D127/D128 4-6 SM Appendix
Code Meaning Suggested Cause/Action
0-52
Polarity changed during
communication

Check the line connection.
Retry communication.
0-55
FCU does not detect the
SG3.

FCU firmware or board defective.

SG3 firmware or board defective.
0-56
The stored message data
exceeds the capacity of the
mailbox in the SG3.

SG3 firmware or board defective.
0-70
The communication mode
specified in CM/JM was
not available
(V.8 calling and called
terminal)

The other terminal did not have a compatible
communication mode (e.g., the other terminal
was a V.34 data modem and not a fax
modem.)

A polling tx file was not ready at the other
terminal when polling rx was initiated from the
calling terminal.
0-74
The calling terminal fell
back to T.30 mode,
because it could not detect
ANSam after sending CI.

The calling terminal could not detect ANSam
due to noise, etc.

ANSam was too short to detect.

Check the line connection and condition.

Try making a call to another V.8/V.34 fax.
0-75
The called terminal fell
back to T.30 mode,
because it could not detect
a CM in response to
ANSam (ANSam timeout).

The terminal could not detect ANSam.

Check the line connection and condition.

Try receiving a call from another V.8/V.34 fax.
0-76
The calling terminal fell
back to T.30 mode,
because it could not detect
a JM in response to CM
(CM timeout).

The called terminal could not detect a CM due
to noise, etc.

Check the line connection and condition.

Try making a call to another V.8/V.34 fax.