Ricoh Kr-P2, Field Service Manual

Page: 158 / 200

5828 066 Job Spooling Clear
This SP determines whether the job interrupted at power off is
resumed at the next power on. This SP operates only when
SP5828 065 is set to 1.
1: OFF (Resumes printing spooled jog.)
0: ON (Clears spooled job.)
5828 069 JobSpooling Protocl
This SP determines whether job spooling is enabled or disabled for each protocol. This is
a 8-bit setting.
0: LPR/ 1: FTP (Not Used)/ 2: IPP/ 3: SMB/ 4: BMLinks (Japan Only)/
5: DIPRINT/ 6: Reserved (Not Used)/ 7: Reserved (Not Used)
5828 090 TELNET
Disables or enables Telnet operation. If this SP is disabled, the
Telnet port is closed.
[0to1 / 1 /-]
0: OFF
1: ON
5828 091 Web
Disables or enables the Web operation.
[0to1 / 1 /-]
0: OFF
1: ON
5828 145 Active IPv6 Link Local
This is the IPv6 local address referenced on the Ethernet or
wireless LAN (802.11) in the format:
"Link-Local address" + "Prefix Length"
The IPv6 address consists of a total 128 bits configured in 8
blocks of 16 bits each. These notations can be abbreviated.
See "Note: IPV6 Addresses " below this table.
5828 147 Active IPv6 Stat 1
These SPs are the IPv6 stateless addresses (1 to 5) referenced
on the Ethernet or wireless LAN (802.11) in the format:
"Stateless Address" + "Prefix Length"
The IPv6 address consists of a total 128 bits configured in 8
blocks of 16 bits each.
5828 149 Active IPv6 Stat 2
5828 151 Active IPv6 Stat 3
5828 153 Active IPv6 Stat 4
5828 155 Active IPv6 Stat 5
3. Appendix: SP Mode Tables
60
3