Ricoh D009, Service Manual

Page: 908 / 1165

Bit Switches
D346 62 SM
System Switch 0B - Not used (Do not change the factory settings.)
System Switch 0C - Not used (Do not change the factory settings.)
System Switch 0D - Not used (Do not change the factory settings.)
System Switch 0E [SP No. 1-101-015]
No FUNCTION COMMENTS
0-1 Not used Do not change the settings.
2
Enable/disable for direct
sending selection
0: Direct sending off
1: Direct sending on
Direct sending cannot operate when the capture
function is on during sending. Setting this switch to
"1" enables direct sending without capture. Setting
this switch to "0" masks the direct sending function
on the operation panel so it cannot be selected.
3
Action when the external
handset goes off-hook
0: Manual tx and rx operation
1: Memory tx and rx operation
(the display remains the
same)
0: Manual tx and rx are possible while the external
handset is off-hook. However, memory tx is not
possible.
1: The display stays in standby mode even when
the external handset is used, so that other people
can use the machine for memory tx operation.
Note that manual tx and rx are not possible with
this setting.
4-7 Not used Do not change these settings.
System Switch 0F [SP No. 1-101-016]
No FUNCTION COMMENTS
Country/area code for functional
settings (Hex)
00: France 11: USA
0-7
01: Germany 12: Asia
This country/area code determines the
factory settings of bit switches and RAM
addresses. However, it has no effect on
the NCU parameter settings and
communication parameter RAM