Ricoh D009, Service Manual

Page: 47 / 1165

Main Machine Installation
SM 1-13 D009/D011/D012/D013
Inst
allation
ƒ Confirm that there is no gap between the stack and the side fences. If you see a
gap, adjust the position of the side fences.
5. Press down the lock to lock the side fences.
6. Repeat this procedure to load paper in the 2nd paper tray.
Initialize TD Sensor and Developer
1. Connect the main machine to the power outlet, switch on the main machine, and wait for
the fusing unit to warm up.
2. Enter Copy SP Mode.
3. Press SP Direct to highlight “SP Direct”, enter 2801, and then press .
4. When the message prompts you to enter the lot number of the developer, enter the
7-digit lot number, press [Yes], and then press [Execute] on the touch-panel. This
initializes the TD sensor.
ƒ
The lot number is printed on the end of the developer package. Recording the
lot number could help troubleshoot problems later. If the lot number is
unavailable, enter any seven-digit number.
5. Press SP Direct to highlight “SP Direct” and enter 2805, press , and then press
"Execute" on the touch-panel. This initializes the developer.
6. Press "Exit" twice to return to the copy window.
Set Paper Size for Paper Trays
1. Press User Tools/Counter .
2. On the touch panel, press "System Settings".
3. Press the "Paper Size Setting" tab.
4. Press the button for the tray to change.
5. Change the setting and press the [OK] button.
6. Repeat for each tray installed.
7. Press Exit twice to return to the main display
ƒ
The 1st, 2nd, 3rd, and 4th paper trays are provided with the paper size switches.
The detected paper size by the paper size switches has priority over the UP
settings. However, if you change the "Auto Detect" with the UP setting, you can
select the paper size.
8. Check the copy quality and machine operation.
Electrical Total Counter
The electrical total counter no longer requires initialization. The new incrementing counter is
set to “0” at the factory.