Ricoh D009, Service Manual

Page: 105 / 1165

DataOverwriteSecurity Unit Type I (D362)
SM 1-71 D009/D011/D012/D013
Inst
allation
1.20 DATAOVERWRITESECURITY UNIT TYPE I (D362)
1.20.1 BEFORE YOU BEGIN THE PROCEDURE
1. Confirm that the DataOverwriteSecurity unit SD card is the correct type for the machine.
The correct type for this machine is " Type I" .
ƒ If you install any version other than " Type I ", you will have to replace the
NVRAM and do this installation procedure again.
2. Make sure that the following settings are not at their factory default values:
ƒ Supervisor login password
ƒ Administrator login name
ƒ Administrator login password
If any of these settings is at a factory default value, tell the customer these settings must
be changed before you do the installation procedure.
3. Make sure that “Admin. Authentication” is ON.
[System Settings] – [Administrator Tools] – [Administrator Authentication Management] -
[Admin. Authentication]
If this setting is OFF, tell the customer this setting must be ON before you do the
installation procedure.
4. Make sure that “Administrator Tools” is enabled (selected).
[System Settings] – [Administrator Tools] – [Administrator Authentication Management] -
[Available Settings]
If this setting is disabled (not selected), tell the customer this setting must be enabled
(selected) before you do the installation procedure.
1.20.2 SEAL CHECK AND REMOVAL