Ricoh D009, Service Manual

Page: 112 / 1165

HDD Encryption Unit
D009/D011/D012/D013 1-78 SM
1.22 HDD ENCRYPTION UNIT
1.22.1 BEFORE YOU BEGIN THE PROCEDURE
1. Make sure that the following settings are not at the factory default settings:
ƒ Supervisor login password
ƒ Administrator login name
ƒ Administrator login password
ƒ These settings must be set up by the customer before the HDD Encryption unit
can be installed.
2. Confirm that "Admin. Authentication" is on:
[User Tools] > "System Settings"> "Administrator Tools"> "Administrator Authentication
Management"> "Admin. Authentication"> "On"
If this setting is "Off", tell the customer that this setting must be "On" before you can do
the installation procedure.
3. Confirm that "Administrator Tools" is selected and enabled:
[User Tools]> "System Settings"> "Administrator Tools"> "Administrator Authentication
Management"> "Available Settings"
ƒ "Available Settings" is not displayed until Step 2 is done.
If this setting is not selected, tell the customer that this setting must be selected before
you can do the installation procedure.
1.22.2 SEAL CHECK AND REMOVAL
ƒ
You must check the box seals to make sure that they were not removed after the