Ricoh D009, Service Manual

Page: 293 / 1165

SP1-xxx: Feed-1
SM 5-7 D009/D011/D012/D013
Service
Ta
bles
ƒ Do not set a temperature that is higher than the setting for SP1105 1
(Roller Center: Trays)
Re-load Temp. Minus: Roller Ends
[0 to 60 / 0 / 1 deg]
004
Sets the reload temperature for the ends of the hot roller. This setting depends
on the target temperature.
Reload temp. = Target Temp – This SP Setting
ƒ Do not set a temperature that is higher than the setting for SP1105 2
(Roller Ends: Trays)
005 to
022
The following SPs adjust the fusing temperature at the center or ends of the
hot roller for each paper type.
005 Roller Center: M-Thick
C1b: [100 to 170 / 145 / 1 deg]
C1c: [100 to 170 / 155 / 1 deg]
006 Roller Ends: M-Thick
C1b: [100 to 170 / 150 / 1 deg]
C1c: [100 to 170 / 160 / 1 deg]
007 Roller Center: Thick 1
008 Roller Ends: Thick 1
[100 to 170 / 130 / 1 deg]
009 Roller Center: Thick 2
010 Roller Ends: Thick 2
[100 to 170 / 150 / 1 deg]
011 Roller Center: Thin
C1b: [100 to 170 / 130 / 1 deg]
C1c: [100 to 170 / 140 / 1 deg]
012 Roller Ends: Thin
C1b: [100 to 170 / 135 / 1 deg]
C1c: [100 to 170 / 145 / 1 deg]
013 Roller Center: OHP: Plain [100 to 170 / 150 / 1 deg]
014 Roller Ends: OHP: Plain
015 Roller Center: OHP: Thick
[100 to 170 / 155 / 1 deg]
016 Roller Ends: OHP: Thick [100 to 170 / 160 / 1 deg]