Ricoh Aficio MP C2030, Service Manual

Page: 324 / 1171

Firmware Update
D037/D038/D040/D041 5-12 SM
ROM/NEW What it means
ROM:
Tells you the number of the module and name of the version
currently installed. The first line is the module number, the second
line the version name.
NEW:
Tells you the number of the module and name version on the SD
card. The first line is the module number, the second line the
version name.
ƒ
Controller, engine and operation panel firmware cannot be updated at the
same time. It is recommended to update firmware modules one by one.
8. Touch “UpDate (#)” (or

) to start the update.
ƒ The progress bar does not show for the operation panel firmware after you
touch “OpPanel”. The power on key flashes on and off at 0.5 s intervals when
the LCDC firmware is updating. The power key flashes on and off at 3 s
intervals when the update is finished.
9. The "Update is Done" message appears on the operation panel after completing the
updating. The message differs depending on the firmware that has been updated.
10. Switch the copier main power switch off when you see the “Update is Done” message
or follow the procedure that is displayed on the operation panel.
11. Press in the SD card to release it. Then remove it from the slot.
12. Switch the copier on for normal operation.
Error Messages
An error message shows in the first line if an error occurs during the download.
The error code consists of the letter “E” and a number. The example above shows error
“E24” displayed. For details, refer to the Error Message Table. ( Section: Handling
Firmware Update Error)
Firmware Update Error
If a firmware update error occurs, this means the update was cancelled during the update
because the module selected for update was not on the SD card.
Rev. 05/07/2009