Ricoh Aficio MP C2030, Service Manual

Page: 492 / 1171

SC Tables
D037/D038/D040/D041 4-70 SM Appendix
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
995 D CPM setting error
ƒ Defective BCU
ƒ NVRAM replacement error
-001
1. Install the previous NVRAM on the BCU.
2. Input the serial number with SP5811-004, and turn the main power
switch off/on.
ƒ Defective NVRAM on the controller
ƒ Defective controller
-002
1. Update the controller firmware.
2. Install a new NVRAM, and turn off and on the main power switch
after SC995-002 has occurred.
ƒ Incorrect type controller installed
ƒ Defective controller
-003
1. Replace the controller with the correct type.
ƒ Incorrect model controller installed.
-004
1. Replace the controller with the correct model.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
Application function selection error
ƒ The application selected by the operation panel key does not start
or ends abnormally.
ƒ Software (including the software configuration) defective
ƒ An option required by the application (RAM, DIMM, board) is not
installed
ƒ Nesting of the fax group addresses is too complicated
997
CTL
B
1. Check the devices necessary for the application program. If
necessary devices have not been installed, install them.
2. Check that application programs are correctly configured.
Rev. 02/2009
NOTE: Refer to the Removal Section for the BCU (4.15.4), Controller
board (4.15.11) and NVRAM (4.15.12) for more information.)
⇒