TRANSFER BELT UNIT
24 February, 1999
6-52
Cleaning Blade Replacement
NOTE: Take care not to get the customer site dirty. Put down a floor mat before
removing the cleaning unit.
1. Turn the lubricant bracket [A] as shown (unhook 2 springs [B] at both ends).
2. Remove the blade [C] (2 screws).
NOTE: Do not touch the rubber area of the blade.
3. After replacing the blade, turn the transfer belt release lever [D] in the direction
shown, and apply setting powder [E] to the entire belt surface, before installing
the cleaning unit.
4. Attach the cleaning unit to the transfer belt unit and turn the joint section [F] of
the cleaning unit [G] in the direction shown above [H], to pressurize the blade.
5. After pressurizing the blade, rotate the belt one turn in the direction shown
above [I], to orient the belt with the blade.
NOTE: Failure to execute steps 3 to 5 may cause the belt to catch on the
blade. This will cause the LCD to display SC452 (transfer belt home
position detection error) or the blade bracket may become bent.
A259R412.WMF
A259R416.WMF
A259R417.WMF
[A]
[B]
[C]
[D]
[E]
[D]
[G]
[F]
[H]
[I]
Summary of Contents for Aficio Color 4006
