RHINO FC-0110, Operator'S Manual

Page: 113 / 166

MAINTENANCE
TR308 04/21 Maintenance Section 5-7
M
A
IN
TE
N
A
N
C
E
© 2021 Alamo Group Inc.
GEARBOX
The gearbox has been filled with lubricant to the test plug level prior to shipment. However, you should check
the oil level at test plug before operating, and frequently thereafter.
The gearbox should not require additional lubricant unless the box is cracked or a seal is leaking. It is
recommended that the dipstick be removed after every 8 to 10 hours of operation and oil added until it is at
proper level.
Figures MntP-R-0328 and MntP-R-0329.
Required lubricant is Multi-Purpose Gear Oil 85W140. The outer gearbox capacity is three quarts and the
center gearbox has a five quart capacity.
NOTE: Overfilling the Gearbox will cause pressure to build up and cause Oil Seals to leak.
ATTENTION: If the Gearbox suddenly starts making an unusual noise, stop at once, check for leaks. Once
located correct the source of noise.
TAIL WHEEL ASSEMBLY
Tail Wheel Bearings are packed at the factory with
heavy-duty bearing grease. Grease Fittings are provided
in the Wheel Hub and Tail Wheel Beam. Grease after
every 10 hours of use.
DRIVELINE LUBRICATION
Many of the equipment components are HEAVY (70 lbs or greater) and Special Lifting
Procedures are recommended. Use lifting assistance such as mechanical assistance, two
people, and proper lifting techniques when connecting or installing the driveshaft to reduce the
possibility of back injuries.
Center Gearbox
Outer Gearbox