RHINO FC-0110, Operator'S Manual

Page: 6 / 166

DEALER to CUSTOMER Pre-Delivery / Operation Instructions
Dealer should inform the Purchaser of this product of Warranty terms, provisions, and procedures that are applica -
ble. Dealer should also inform the Purchaser to review the contents of the Operator’s Manual including safety
equipment, safe operation and maintenance, to review the Safety Signs on the implement (and tractor if possible)
and of Purchaser’s responsibility to train his/her operators in safe operation procedures.
.
•
IMPLEMENTS: I have explained that Deflectors, Chain Guards, or Solid Skirts must be installed and main -
tained in good repair
•
DRIVELINES: I have made certain that all driveline, gearbox, and other shields are in good repair and fastened
securely in place to prevent injuries from entanglement or thrown objects.
•
HYDRAULIC MACHINES: I have explained the necessity of using clean hydraulic oil, changing filters as
instructed, stopping leaks, damage caused by operating with over-heated oil, caring for hoses, using hoses of
proper rating, maintaining the specified operating pressure and the potential hazard of oil’s penetrating the
skin.
•
FOLDING-TYPE IMPLEMENTS: I have explained that it is not possible to guard against thrown objects when
the head is lifted off ground and that operator is responsible to watch out for persons in the area. I have
explained that the lifted mower head or boom can contact overhead obstructions with damage to cables and
telephone lines and possible injury. I have explained that the extended head or boom or retracted boom can
contact power lines with resulting electrocution, injury or death and that operator is responsible for keeping
clear of such hazards.
PRE-DELIVERY SERVICE
CHECK AND ADJUST OR LUBRICATE AS REQUIRED
See Operator’s Manual for Details
Inspection Performed - Warranty and Safety Procedures Explained - Installation Complete
LUBRICATION & HYDRAULICS MOWER TO TRACTOR CONNECTIONS

Gearbox (Oil Levels)

Draw Bar Length (Check And Set)

Hydraulic Oil Level (External Tank)

A-Frame Pivot & Links

Tractor Hydraulic Oil Level

Control Rods (Adjusted Equal)

Hydraulic Hoses (Not Kinked Tighten Connections)

Axle Height (Adjusted)

Front Pump Drive (Assembly Is Tight And Shaft Properly
Aligned)

Cutting Height (Adjust)
MOWER

Mount Kit-Pre-Operation Check Complete

Spindle And Motor Bolts Properly Torqued

Mower Wing (Adjust Level With The Center)

Spindle Oil Level

Mower Wing (Check For Proper Raising Operation)

Blade Carrier Bolts Properly Torqued/Retaining Pin In
Place

C.V. Drivelines (Check Max Turn Radius)

Mower Cutting Height And Level Adjusted

Pull Type Hitch (Height Adjustment)

Cutting Shaft Bearings Lubricated

Mounting Hardware Properly Torqued

All Hardware Properly Torqued
SAFETY ITEMS

Tire and Air Pressure/Lug Nuts (Correct Torque)

Protective Shields (Operation And Installation)

Wheel Bearings (Check, Grease, and Preload)

Driveline Clutch (Torque Limiter) (Adjust And Run In)
ATTACHMENTS & INSTALLATION

Safety Decals (Installed)

Deflectors Front And Rear

Operator’s Manual (Supplied)

Shredding Attachments

Tractor PTO Shield (Installed)

Correct Blade Rotation Direction

S.M.V. Emblem (Installed If Needed)

Axle Arms And Beams

Tongue Jack (Installation and Operation)

Tongue And Control Rods (Installed And Adjusted)

Safety Tow Chain (Installed)

All Bolts - Pins And Nuts (Proper Torque)

ADMA Driveline Safety Manual Supplied

AEM Mower Safety Manual (Supplied in Canister)

AEM Mower Safety Video has been shown to Pur -
chaser