RHINO FC-0110, Operator'S Manual

Page: 115 / 166

MAINTENANCE
TR308 04/21 Maintenance Section 5-9
M
A
IN
TE
N
A
N
C
E
© 2021 Alamo Group Inc.
MAIN & JACKSHAFT DRIVELINE SHIELD
To remove the main inner driveline shield, Remove the locking screws. Align the bearing tabs with the cone
pockets.
FIGURE Mnt-0026.
Remove the half-guard and remove the bearing ring.
FIGURE Mnt-R-0012.
Inspect the driveline shield for worn areas or cracks. If the shield has any dents or cracks, replace the Shield.
While the Shields are off, examine the Driveline for signs of abnormal wear, bent or twisted shafts, or cracks in
the shafts or tubes. Check to see that the Drivelines telescope easily. If the Drivelines do not telescope
properly or show signs of abnormal wear, the shaft should be repaired or replaced.
To assemble the main inner driveline shield, grease the yoke groove and inner profile tube. Attach the bearing
ring in groove with recesses facing profile tube. FIGURE Mnt-0027. Slide on the half shield. Turn the cone until
it engages correctly. Install locking screws. FIGURE Mnt-0028.
IMPORTANT : Scan this QR Code with your smart phone to link to the ADMA Driveline
Safety Manual for more information on the safe use of a driveline during normal
operation and maintenance. Or type in your internet browser the following web
address: www.algqr.com/dme
Ops-0009-MISC str
IMPORTANT!
Check that Guard
Missing decal on
steel tube under
inner guard and
Rotating Driveline
Decal are firmly
affixed, undamaged
and readable. If not,
replace.