RHINO FC-0110, Operator'S Manual

Page: 105 / 166

OPERATION
TR308 04/21 Operation Section 4-47
O
PE
R
AT
IO
N
@ 2021 Alamo Group Inc.
15. TROUBLESHOOTING GUIDE
Problem Possible Cause Remedy
Uneven Cut Excessive ground speed. Reduce ground speed.
Blades worn, dull or bent. Replace blades.
(Refer to “Maintenance” Section)
Mower not level side to side. Adjust. (Refer to “Assembly” Section)
Improper height adjustement. Adjust mower height.
(Refer to “Assembly” Section)
Low tractor tire pressure on one side. Adjust tire prersure. (Refer to your tractor
Operator’s Manual)
Turning too fast. Reduce ground speed when turning.
Tractor tires push grass down. Adjust your tractor wheel spacing.
(Refer to "Operation" section)
Damaged Mower pan. Repair or replace as necessary.
Uncut Material Excessive ground speed Reduce ground speed.
RPM too low Use full PTO speed. (Refer to
your tractor Operator's Manual)
Improper blade for direction of cut. Install blades so rotation is correct.
Poor Shredding Excessive ground speed. Raise the front of Mower relative to the
rear to hold and circulate material
longer. (Refer to the "Operation
Section-Setting the Mower-Setting
Deck Height”) Reduce ground speed.
Cutting too high. Lower cutting height. (Refer to the
"Operation Section-Setting the Mower-
Setting Deck Pitch”)
Windrowing or
Uneven
Distribution
Material heavy and lush. Raise the front of Mower relative to the rear.
(Refer to the "Operation Section-
Setting the Mower-Setting Deck Height”)
Excessive ground speed. Reduce ground speed.
Conditions too wet. Wait for conditions to dry. Reduce ground
speed.
Blade Bolts
Working Loose
Bolts not tighened. Tighten Bolts to 300 ft./lbs.
Bolt hole elongated or oversized Replace Blade Carrier.
Locknut worn out. Replace Locknut.