Safety Precautions
12
STEP 7
STEP 6
Plug the power cord into a grounded electrical
outlet.
NOTE:
An electrical surge protection unit is
recommended
(not included).
CUSTOMER SERVICE: 800-973-8374
Power Base Assembly Instructions
remote control to verify that all of the features
are operational. If your Power Base does NOT
operate, please refer to the
Troubleshooting
section near the end of this manual.
NOTE:
ProGrip™ Base uses a
material near the foot
end to help prevent the
mattress from sliding off
the base when operating
head and foot lifts.
STEP 9A
STEP 9B
Use the Retainer Bolts (D) and Retainer
Bar Plate (E) to fasten the Mattress Retainer
Bracket (B) to the power base.
If you have a center foot retainer bar, then
follow the instructions below.
•
shown when bed arrives
•
Loosen both bolts and slide the center bar out
• Turn bar over so standing upright and slide
bar back around bolts and under washers
as shown.
•
’
much or the washer plate will bend.
NOTE:
Use only a manual screwdriver to
install the retainer bolts. DO NOT use a
power screwdriver to tighten the bolts. DO
NOT over tighten the mattress retainer
hardware.
STEP 8 (RETAINER BARS)
ONLY INSTALL AT THE CUSTOMERS
REQUEST. Customers should try the ProGrip
staying on the base when elevated then we
recommend the customer installing 2 retainer
bars at the foot end of bed. See STEP 9 to
install the corner retainer bars.
