ResMed S8 AutoSet Vantage, User Manual

Page: 33 / 209

28
1 I
NSERT THE
D
ATA
C
ARD
•
Switch on the
S8 A
UTO
S
ET
V
ANTAGE
and wait until you see the standby (RAMP
or SETTLING) screen.
•
Hold the Data Card with the arrow facing up, and insert it into the slot in the
Data Card module (
H-1
).
•
Push the card in smoothly until it stops moving (
H-2
) and messages start
appearing on the LCD.
2 C
OPY
D
ATA ONTO THE
D
ATA
C
ARD
•
Data copying starts automatically when the Data Card is inserted into the Data
Card module.
•
The “Card Inserted Please Wait” message is displayed on the
S8 A
UTO
S
ET
V
ANTAGE
LCD while data is being copied. Copying takes up to 30 seconds.
•
The “Copy Complete Remove Card” message is displayed on the LCD when
copying has finished.
•
Remove the Data Card from the Data Card module.
3 R
EMOVE THE
D
ATA
C
ARD
Grip the end of the Data Card and pull it out of the Data Card module (
H-3
).
4 S
TORE THE
D
ATA
C
ARD
Your Data Card should be stored in its mailback envelope when not in use.
5 M
AIL THE
D
ATA
C
ARD TO YOUR
C
LINICIAN
A bubble mailer envelope is provided to ensure safe transportation of the Data Card.
When mailing the Data Card to your clinician:
1. Insert the Data Card into the pocket provided on the mailback envelope. Fold up
the mailback envelope.
2. Place the mailback envelope containing the Data Card in the bubble mailer
envelope and seal it.
3. Make sure that your clinician’s name and address details are on the bubble mailer
envelope, and mail it back immediately.
U
SING THE
D
ATA
C
ARD TO
U
PDATE
S
ETTINGS
If your clinician has provided a Data Card with new device settings:
•
With the device in standby (RAMP or SETTLING) mode, insert the Data Card
into the slot on the Data Card module. Updating will start automatically.
•
The “Card Inserted Please Wait” message is displayed on the LCD while updating
is in progress. Updating takes up to 30 seconds.
•
The “Settings Success Remove Card” message is displayed on the LCD if the
settings were updated successfully.
Note:
This message only appears once. If you re-insert the Data Card after you have
updated your settings, this message is not displayed.
•
Remove the Data Card from the Data Card module.
•
Store the Data Card in its mailback envelope when not in use.
33887r2.book Page 28 Thursday, June 30, 2005 1:36 PM