Renfert duomix II, Manual

Page: 17 / 92

- 3 -
1. Introduction
1.1 Symbology
The following symbols are employed in these instructions and on the unit itself:
On the unit:
Adhere to the operating instructions!
In these instructions:
Caution
Serious risk of injury!
Electrical current
This indicates a hazard due to electrical current.
Attention
Failure to observe the associated information can result in damage to the unit.
Note
This provides the operator with useful information to make working with the unit easier.
Please observe the operating time.
After no more than 2 minutes of operation, you must pause for at least 5 minutes.
The unit complies with current EU directives.
Within the EU, this device is subject to the provisions of the WEEE directive.
Required actions, correct order •
Reaction ○
Listing −
Other symbols are explained as they occur.
1.2 EU Conformity
Renfert GmbH hereby declares that this product:
DUOMIX II
Order no.: 276100-0000, -1000, -2000, -3000
complies with the following European directives:
93/42/EEC, Medical Products Directive, Annex VII −
2. Safety
Using these operating instructions as a starting point, instruct all operators of the unit with re-
gard to the area of application, the possible hazards during operation, and the proper operation
of the unit.
Please have these operating instructions readily available for the operators.
2.1 Proper Use
The
DUOMIX II
is designed solely for the extrusion of 2-component precision impression materials.
With the
DUOMIX II
it is possible to use 5:1 cartridges or pouches in support cartridges from various
manufacturers.
Dynamic mixing nozzles with hex drive are used to mix the material.
Always comply with all safety and processing instructions provided by the manufacturer!
Only the mixing nozzles specified by the manufacturer may be employed.
EN