Checking the burner operation
When the room thermostat commands the burners
of the connected hot air generators to switch on
(both in "MANUAL" mode and after "TIMER"), the
"BURNER ON" symbol appears in the Status sec-
tion
(
). The
3.3 ‘Management of the GPC Smart Processor ’
) on the main screen page is used to
display the operating status of the hot air genera-
tors. This menu accesses a display with a number
of lines corresponding to the number of units con-
figured in the network, the value in column "N" is
the address of the respective unit set on the GPC
Smart Processor. If the symbol
appears in the
last column (column "M"), the burner of the unit
corresponding to this line is switched on. If, on the
other hand, no symbol appears, the burner may be
in a switch-on or switch-off cycle, or the setpoint
may already have been reached, or it may not be
configured correctly. If the symbol appears in
the same column, this means that the corre-
sponding unit is in fault condition.
10:15
CPU-Smart
N.
Cod
Tout
M
01
F21
0008
02
===
0000
03
===
0005
OK
RST
TOUT
10:15
HOME
SET: 18°C
20.0
°C
OK
000 %
!
Mon 01 Jan
Mon 01 Jan
Fig. 24: Check burner operation
Settings
This menu can be used to select and configure the
desired type of control for the room temperature
controller. The "SETTINGS" menu is accessed via
the
key (D) in the main menu. Within these
menus you can select one of the following options:
n
ON/OFF
n
PID
n
Cascade
10:15
MENU
A
F
C
B
E
D
10:15
PID
Kaskade
ON/OFF
Einstellungen
OK
A
ON/OFF
10:15
PID
Kaskade
ON/OFF
Einstellungen
OK
Mon 01 Jan
Mon 01 Jan
Mon 01 Jan
Settings
ON/OFF
ON/OFF
PID
Cascade
Settings
PID
Cascade
Fig. 25: Settings
REMKO room temperature controller
28
