REMEHA Avanta Plus 24s, Installation And Service Manual

Page: 127 / 153

10
Remeha Avanta Plus
R
3x
LTNLW6H000073A
R
4x
LTNLW6H000074A

In the comfort mode the boiler will be seen to run
occasionally even if time clocks are in the off position.
0 = Comfort mode
1 = Eco mode
2
= regulated by controller (= factory setting)
Change the mode as follows:
LT.NL.W6H.000.073
•
Press
‘Enter’- key
until codes
p [
and
[ 1
are dis-
played alternately.
•
Press
[+]- key
3x until codes
p [
and
[ 4
are dis-
played alternately.
•
Press
‘Enter’- key
; setting of ‘eco or heat retention’ mode
is displayed (mode
2
= heat retention and regulator-
dependent, factory setting).
•
Press
[-]- key
to change this mode, for example mode 1
(=eco mode).
•
Press
‘Enter’- key
to confirm this mode; codes p [ and
[ 4 are displayed alternately.
•
Press
‘Reset’- key
to switch boiler to operating mode.
Changing P5 setting: (no) anticipated current

Boiler responds to temperature changes after a certain time,
input via on/off thermostat. Response time can be reduced by
enabling ‘Anticipated current’ option (only when the on/off ther-
mostat has an anticipation current setting device). When the
boiler is installed this setting has been already been adjusted.
Ask your service engineer for further details.
Change the anticipated current (if necessary) setting as fol-
lows:
LT.NL.W6H.000.074
•
Press
‘Enter’- key
for 1 second until codes
p [
and
[
1
are displayed alternately.
•
Press
[+]- key
4x until codes
p [
and
[ 5
are dis-
played alternately.
•
Press
‘Enter’- key
; (no) anticipated current setting is dis-
played (mode 0 = no anticipated current, factory setting).
•
Press
[-]- key
to change this mode, for example mode 1
(=anticipated current).
•
Press
‘Enter’- key
to confirm this mode; codes
p [
and
[ 5 are displayed alternately.
•
Press
‘Reset’- key
to switch boiler to operating mode.