REMEHA Avanta Plus 24s, Installation And Service Manual

Page: 125 / 153

8
Remeha Avanta Plus
LTNLW6H000070A
R
•
Press the
[+]
key again until
t4
appears and, for exam-
ple, 18 (18°C), the current outside temperature;
•
Press
[+]
key again until f l appears and e.g. ^0
(6uA), the present ionisation current;
•
Press
[+]
key again until ñf appears and e.g. 30
(3000 rpm), the present fan speed;
•
Press
[+]
key again and the read-out cycle will start again
with t1 , etc.;
•
Press
‘Reset’- key
to return to the display with the cur
rent operating status.
3.3 Changing settings
The user can change the following settings:
p
1 Maximum flow temperature (= water temperature that
leaves the boiler) [°C], adjustable between 20 and 85°C
(factory setting = 75°C)
p 2 Maximum domestic hot water temperature [°C], adjust-
able between 40 and 65°C (factory setting = 55°C)
p 3 Boiler regulation; central heating and domestic hot water
mode adjustable at four levels:
0 = central heating OFF and domestic hot water OFF
1 = central heating ON and domestic hot water ON
(= factory setting)
2 = central heating ON and domestic hot water OFF
3 = central heating OFF and domestic hot water ON
p
4 Eco or comfort mode adjustable at 3 levels:
0 = comfort setting
1 = eco mode
2 = regulated by controller (= factory setting)
p 5
Anticipated current for on/off thermostat (ask your ser-
vice engineer for further details)
0 = no anticipated current (= factory setting)
1 = anticipated current
p 6 Display off automatically
0 = display stays off
1 = display stays on
2 = display switches off automatically after 3 minutes
(= factory setting)
Changing P1 setting: flow temperature of water in central
heating system
LT.NL.W6H.000.070
Reduce the flow temperature as follows:
•
Press
‘Enter’- key
until codes
p [
and
[ 1
are dis-
played alternately.
•
Press
‘Enter’- key
again; set value for maximum flow
temperature is displayed: 75°C (factory setting).
•
Press
[+]
or
[-] -key
to change this value, for example to
70°C.
•
Press
‘Enter’- key
to confirm value; codes p [ and [
1 are displayed alternately.
•
Press
‘Reset’- key
to switch boiler to operating mode.

Summer holidays
In summer a reduced flow temperature setting may be ade
quate for your heat requirement. Reduce the flow temperature
and save energy.