REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual EXELLE JUNIOR 21
SERVICE MANUAL
SIDE GUARD
Rotative system
It is advisable to pread a drop of
mild lock thread glue on the grab
screws
C
and
G
and on the bolt
F
.
Follows next page
After any adjustment of the rear wheel, you will have to adjust the position of the side
guard accordingly.
You should adjust the side guard at approximately 5 mm from the tyre.
You can adjust the side guard in height and depth.
The side guard is fixed through an eccentric ring that, in its turn, is fixed through the
bolt
A
through the support
S
.
To carry out the adjustment, proceed as follows.
Insert the rear wheel and, if there is no interference with sideguard, you keep it on. On
the other hand, remove the wheel and proceed.
The system consists of the rotation of two components.
A
rotation of the whole system (side guard and ring fixed together);
B
rotation of the side guard on the ring.
The combination of these two rotations allows for the adjustment.
A
A
ROTATION OF THE WHOLE SYSTEM
Loosen the nut
B
that is located in the inner side of the frame and the
headless bolts
C
. That will allow for the rotation of the whole system
pivoting it on the bolt
A
(in this phase, the ring and the side guard are
still fixed to one another).
To rotate the whole system, just take hold of the side guard with one
hand and rotate it clock/anticlockwise.
Note: if you loosen the nut
B
too much, it may happen that the bolt
A
moves as far as to have its square neck
D
off its corresponding bed
E
on the ring. Therefore, when you screw the bolt
A
, pay attention this bolt
is correctly inserted in the ring, otherwise it will not be possible to tight-
en the nut
B
and, consequently, the whole system.
D E
A
B
A
B
C
A
S
