REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual EXELLE JUNIOR 38
SERVICE MANUAL
BACKREST HEIGHT
Standard rear frame
When both rear height and backrest height are very low,
one or two bolts/washers/nuts
C
that fix the
rear wheel plate, can also fix the backrest tube.
If the backrest tube is already fixed with
one or two bolts/washers/nuts
C
, remove such bolts, position the
backrest to the wished height and fix it with the bolt/washer/nut
B.
Finally, fix the rear wheel plate.
If the backrest tube, when lowering it, stops against
the bolt/washer/nut
V
before reaching the wished
height, remove the bolts
C
, position the backrest tube at the wished height and fix it with the bolt/washer/nut
B
. Then, through the holes of the rear wheel plate and, consequently, through the tube’s holes, pass a 6 mm
drill pin. Finally, fix the rear wheel plate.
For this rear frame, the tubes are available in two sizes that allow for different height.
Usually, the backrest tube is fixed through the hole
F1
that allows for backrest height from 28.5 to 42 cm
(short tube) or from 40.5 to 54 cm (long tube).
If you lower the tube over the last hole, you can fix it with the bolts
C
(that may fix the rear wheel plate, too).
In such case, you have to widen the hole to 6 mm. The minimum height you can reach is 25 cm (with long
tube, you have to cut it off 10 cm approx.).
To have higher heights, you can fix the tubes through the
hole
F2
as long as you leave at least 8 cm of tube below
the fixing point.
To reduce possible play and possible noise, you can put
some sticky tape around the backrest tube at its bottom
and at just above the last hole
.
C
Remove the backrest upholstery.
If side guards are present, partly fold the
crossbar and remove the bolt/washer/
nut
A
. Move the rear wheel off by 2-3
cm without removing it.
Turn the side guard up backward. Slide
the backrest band along the frame until
you get access to the bolt/washer/nut
B
.
Remove bolt/washer/nut
B.
Raise or lower the backrest height to the
wished position.
Fix the bolt/washer/nut
B.
A
B
