REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual EXELLE JUNIOR 19
SERVICE MANUAL
SIDE GUARD
Standard rear frame
Follows next page
B
B
A
E
D
D
C
C
C
C
After each adjustment of the rear wheel, you have to adjust the position
of the side guard accordingly.
You should adjust the side guard at approximately 5 mm from the tyre.
It is fixed with the bolts
B
to the aluminium support
A
that has two series
of slots
C
.
The support
A
is fixed to the frame in two points with the bolts
D
that
also fix the crossbar tube supports
E
.
Every side guard is shaped to measure according to the configuration of
the wheelchair when originally assembled.
The shape of the side guard always allows for a reasonable good range
of adaptation.
Note: if the side guard is straight, you can decide to modify it or not.
A
When you decrease the rear height
, you have to move the side guard
up.
1. After adjusting the rear height, remove bolt/washer/nut
B
and remove
the side guard.
2. Insert the rear wheel. Position the side guard at approximately 5 mm
from the tyre and parallel to it.
3. Holding the side guard at 5 mm from the tyre, mark the points where
you will have to drill the two new holes.
4. To do so, use a pointed tool and let it through the slot
C
of the plate. It
is advisable to mark it in the middle of the slot. If the rear height ad-
justment is remarkable, you may need a new side guard.
5. Drill a 5 mm hole on the mud guard where just marked.
6. Countersink the hole
7. Insert bolts/washers/nuts
B
and screw without tightening.
8. Insert the rear wheel and d position the side guard.
9. Tighten the bolts/washers/nuts
B
.
