REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual EXELLE JUNIOR 42
SERVICE MANUAL
SEAT WIDTH ENLARGEMENT
Standard and Dynamic 2.0 rear frame
Follows next page
D
A
C
B
B
B
C
D
D
A
C
A D C
Remove the bolts/washers/nuts
B
that fixe the side guard
aluminium support
A
to the frame.
It is not necessary to remove the side guard from the
aluminium support.
You have to replace the bolts
B
with a 5 or 10 mm longer
one according to the wished enlargement.
Insert the longer bolts
B
through the hole of the support
A
, add one or two 5 mm spacers
D
between the support
A
and the crossbar tube support
C
and tighten
Note: while fixing the bolts
B
, you have to hold the spac-
er
D
aligned with the support
C
. In case you add two
spacers, they can move between one another. You may
even glue the spacers, but this is normally not necessary.
Now, it is necessary to check the gap between side
guard and rear wheel and decide whether or not, to add
spacer on the wheel receiver
.
In such case, remove the wheel receiver and add 2.5
and/or 6 mm spacers.
Advice: before removing the receiver, it is useful, as a try,
put the spacer on the axle of the wheel and put it on. This
way, you will immediately see what spacer you need.
Check and, if necessary, adjust the brake.
