REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual EXELLE JUNIOR 23
SERVICE MANUAL
SIDE GUARD
Rotative system
It is advisable to pread a drop of
mild lock thread glue on the grab
screws
C
and
G
and on the bolt
F
.
Follows next page
D
FIXING THE WHOLE SYSTEM
Tighten the bolt
F
and the two grab screws
G
- see also
B
(
ROTATION OF THE SIDE GUARD ON THE RING)
If the bolt
F
is not accessible after you positioned side guard, tighten the two headless bolts
G
, then, taking care of not letting the side guard
turn on the ring, rotate the whole system clock/anticlock wise until you will be able to get access to the bolt and tighten it.
If necessary, slide the wheel off by 3 cm to allow the side guard passing.
Note: the bolt
F
may be “hidden” just by the seat tube of the crossbar, in such case, fold the crossbar as much as necessary.
Turn the whole system back to the correct position.
Tighten the nut
B
hard while holding, checking and, if necessary, correcting the position of the side guard that may move. Finally, tighten the
headless bolts
C
.
See also
A
(ROTATION OF THE WHOLE SYSTEM)
Before tightening the nut, open the seat and let it lock to the four supports. Two of such supports are inte-
grated to the side guard support. Make sure to position/hold the support, thus the side guard, perpendicular
to the ground.
NOTES
These kind of side guards (plastic or carbon fibre) allows for 5-6 cm range of adjustment.
Therefore, it may be necessary to change the side guards with smaller or larger ones.
The height
H.
can be:
21 cm (mini);
25 cm (small);
28 cm (large).
If the position of the side guard is not satisfactory, you can also work on the sliding support
S
that you can assemble in front or behind the rear wheel plate upper support
L
.
To slide the support
S
just loosen the two bolts
M
and the two grab screws
N
present on the
upper side of the support (you have to fold the crossbar to get access to them). To move it
in front or behind the support , remove the two bolts
M
(by doing so, you can remove the
block
O
)
,
remove the support
S
and fix it to the new position.
Once you find a suitable position, insert the block
O
, tighten the bolts
M
and the two grab
screws
N
.
H.
Aggancio tubo
seduta
S
S
L
M
N
O
C
F
C
N
B
O
M
L
