67
Zone 1
......................... Any free terminal C2 to C9. The appropriate terminal must then be selected in the
input management.
Zones 2 to 6
............... Add-on modules.
Wireless WiFi room sensor
First select the power supply method in the sensor (either from the battery
"BAT"
or from the USB
"USB"
)
- the
"POWER"
switch on the printed circuit board of the wireless sensor is used to select the power
supply. After pressing the
"WiFi settings"
button, the blue LED lights up and the WiFi sensor creates an
access point (hotspot) called
"Regulus_RSW"
.
It is necessary to connect to this access point using a PC or mobile device and set the parameters needed
to connect the sensor to the Controller - the IP address of the Controller and the parameters of the WiFi
network. The sensor shall be connected to the same network as the controller, or to the USB WiFi module
of the IR14 Controller, if it is in Hotspot mode.
