18
|
Regency Horizon® HZ40E-10 Gas Fireplace
|
18
installation
FRAMING & FINISHING
Important:
Determine the nailing strip position by determining the facing material being used.
Examples:
1/2" non-combustible wall board for clean inish = 2-3/4" adjustment.
1/2" non-combustible wall board + 1/2" tile = 1" of inished material
= 2-1/4" adjustment.
Note:
Depending on the material used for inishing, the nailing strips must be set ac
-
cordingly so that the inished material is always at the 3-1/4" edge of the lange.
Finished
Material
Nailing Strip
Position
1/2"
2-7/8"
1"
2-1/4"
3-1/4"
0" (lush)
Unit
Nailing Strip
1 Forward
Unit
Nailing Strip
½ Forward
Unit
Nailing Strip
Flush w/unit
Factory Set
2-3/4"
2-1/4"
Finished material
Finished material
Finished material
IMPORTANT
Regency Fireplace Products are designed, produced, tested and certiied to the highest industry standards.
The inishing of the walls surrounding your Regency Horizon Fireplace is as critical as the installation itself.
The temperatures around linear gas ireplaces are typically higher than would be acceptable for combustible materials. Your Regency
Horizon Fireplace is no exception to this rule. Therefore, the units are speciied with non-combustible required materials to speciic
dimensions above and around the units. This is due to these areas reaching higher temperature levels than required/acceptable for a
combustible material. To obtain the best, most durable inish around your ireplace, this calls for a high level of care and attention to the
preparation and inish around this appliance, using only the highest quality materials, able to withstand the temperatures produced.
By following the installation instructions in the manual exactly, you will increase your chances of a damage free inish.
While every precaution is taken in providing the recommendations on preparation and inish, given the variations in paint quality, with
temperature limits and workmanship in application, Regency is unable to guarantee the life of the joint compounds, paint or any other
inish materials or workmanship applied to or used in any application surrounding the ireplace. This includes framing as well as inishing.
Over time natural convection from any ireplace can cause discoloration in the area directly above the appliance. Lower quality paints,
under-prepared inishes, poor applications, and any framing discrepancies or in the installation can cause this discoloration process to be
expedited.
Discoloration is not the responsibility of Regency Fireplace Products. This is out of the control of Regency Fireplace Products Ltd.,
therefore not covered under any part of the warranty policy.
While discoloration is not the responsibility of Regency Fireplace Products, we believe careful attention to the recommendations provided
here will result in an aesthetically pleasing result free of issues outlined above.
