AN-30e
user manual
70-00035-01
Proprietary Redline Communications © 2004
November
16,
2004
Page 56 of 103
Payload
: The framer rebuilds the coding/framing information.
Figure 31: TDM Loopback: Payload Mode
Step 3. Save Settings
Send
: Click Send to save the general settings. If you do not click Send, the changes
will be discarded when you exit this screen.
Note: Clicking Send does not permanently save the current settings or make these
settings active. You must click Send and then click Save in the TDM General
Configuration screen to permanently save any new settings for the TDM board.
5.9.4 TDM Config - Bundle Selection
The TDM Bundle Configuration settings allow you to send full or fractional channels
over the wireless. Use of fractional channels can preserve bandwidth by sending data
for only the designated sets of timeslots.
The TDM Bundle Configuration settings allow you to specify up to eight full or
fractional E1 bundles. Use of fractional services can save bandwidth by sending only
the designated sets of timeslots. Framing must be selected on ports where fractional
bundles are specified.
TDM signals are transported by encapsulating timeslot data within Ethernet packets.
The AN-30e supports multiple packet streams, each grouping one or more timeslots.
Each bundle may be assigned a separate destination address. If Fractional E1 is used,
multiple bundles can be defined to a single port. This feature allows multiple
fractional channels from remote-end AN-30e systems to be combined onto a single
port of a network-connected AN-30e system.
Figure 32: TDM Bundle Selection
TDM Bundles
: Use this drop-down menu to select a bundle.
Config
: Edit the selected bundle definition.
Delete
: Delete the selected bundle definition.
Add
: Create a new bundle definition.
