AN-30e
user manual
70-00035-01
Proprietary Redline Communications © 2004
November
16,
2004
Page 42 of 103
Figure 19: System Configuration Screen - Wireless Settings
RF Freq. [MHz]
: The system is shipped with a default RF setting. This setting must
be changed before allowing the radio to transmit. Channel availability is dependent
on the regional regulatory requirements.
Enter the channel center frequency of the system. The table below specifies the center
frequencies of each permitted channel. To avoid interference, the channel frequencies
of two links operating within close proximity must be separated at least twenty MHz.
The availability of frequency bands listed in the following tables is based on the
factory entered option key.
Auto Scan
:
Check this box to enable subscriber systems to scan the frequency
band for active base stations. The availability of channels is limited by regional
regulations.
It is important that this feature is enabled on the subscriber system when the master-
end system has DFS Action is set to Chg Freq. This setting allows automatic link
recovery following a DFS event.
Additional detailed installation information is available in the manual titled
"Installation Guidelines for Redline AN-30e PTP Systems" also provided on AN-30e
CD-ROM. This guide provides instructions for site planning and installation
including weatherproofing and antenna alignment.
