Re Revision II Plus Touch, Instructions For Installation, Use And Maintenance Manual, Page: 53 / 56

Re
S.p.A. ReVision II plus Touch
Rev. 21/05/13 50/51
Disassembly and dismantling
Caution!
Before dismantling the ReVision II plus Touch system, switch off the machine to which it has
been applied so that also the viewing system is off.
Caution: due to the presence of capacitors in the video camera and DSP Touch, high
voltages may be present even when the system is switched off.
To disassemble the
ReVision II plus Touch from the machine simply remove the 2 screws used to fix the
motorized rail to the machine (see figure on page 3)
Information about device recovery
- In European Union member states
The device falls within the electrical and electronic equipment category, which must be disposed of not
amongst undifferentiated urban waste, but through separate collection. Therefore, at the end of the
device’s lifetime, it must be disposed of in conformity with the European standards adopted in the
member state in which it was installed.
WEEE (Waste Electrical and Electronic Equipment) may be intended for individual, collective or mixed
collection and recovery systems at designated centres (for more information contact the relevant local
authorities) or may be returned to the distributor when a new item of equipment is purchased. This
eliminates or reduces potentially negative effects on the environment deriving from improper use of the
equipment or parts of it.
For correct waste management, the relevant authorities promote the reduction of final waste disposal by
means of re-use, recycling and other forms of recovery to obtain raw materials from waste.
In the event of illegal disposal of WEEE, offenders will be punished in accordance with the sanctions
established by the member state in which it was installed.
- In non-EU countries
Recovery and final disposal of the device must be carried out in conformity with the standards in force in
the country in which it was installed. It may be advisable to take into account the information provided
regarding European Union member states.
When disassembling and dismantling the viewing system always
wear safety gloves and boots and observe all the safety norms
required for the environment in which it is located.
The device bears a clear, visible and indelible indication allowing identification of the
manufacturer and the separate collection symbol (symbol on side).
This symbol, showing a wheelie bin with a cross through it, unequivocally indicates that
the device was released after 13.08.2005 and that it must be subject to separate
collection.