Re Revision II Plus Touch, Instructions For Installation, Use And Maintenance Manual, Page: 45 / 56

Re
S.p.A. ReVision II plus Touch
Rev. 21/05/13 42/51
Troubleshooting
Problem Possible causes Remedies
System does not start No DSP Touch power Connect the DSP Touch to the 24V
dc power supply
System starts but monitor does
not come on
The VGA connecting cable or the
monitor power cable are
disconnected
Check that both cables are
connected
System starts but monitor only
shows flashing cursor
The DSP Touch / camera
connecting cable is disconnected
Switch off the system and connect
the disconnected device to the DSP
Touch / camera cable
System starts but does not
respond to touch screen
commands
The touch screen USB connecting
cable is disconnected
Connect the monitor USB cable
System does not acquire images
when machine is moving
The system is set to Stop Press the mode button until the
system switches to the Run state
Two sensors were selected but only
one sensor is connected
Go to the set-up page and select just
one sensor by using the sensors
number button
(use the unlock/lock button to
remove unlock the protected
commands)
One of the two external sensors is
not positioned correctly
Check the position of the sensor(s)
System does not acquire images
when machine is stopped
The system is set to Stop or Run Press the mode button until the
system switches to the Test state
System acquires images but
synchronization is impossible
The system is set to Test Press the mode button until the
system switches to the Run state
An incorrect number of teeth was set Check the number of teeth and set
the correct value in the set-up page
by using the teeth number and +
and - buttons
Sensor 1 is not positioned correctly Check the position of the external
sensor
System functions but images are
acquired at a very slow rate
The position of the external sensors
is inverted
Swap the position of sensor 1 and
sensor 2
Number of revolutions per flash is
set too high
Go to the Revolutions per flash
function and reduce the number set