Re Revision II Plus Touch, Instructions For Installation, Use And Maintenance Manual, Page: 10 / 56

Re
S.p.A. ReVision II plus Touch
Rev.21/05/13 7/51
d. Remove the screw from the belt tightening block and insert the belt.
e. Scroll the belt tightening block so that the belt is tightened, then place again the screw and
tighten it.
Caution!
Over tightening the belt could stop the camera stroke. If this happens, slacken the belt
slightly so that the camera can start up again.
6. Secure the rail to the machine so that the camera is 10mm from the material in the case of
ReVision II versions MH-100 , LD-100 and CV-350 or 15mm from the material in the case of
versions RF , MH-75 and LD-75 , with tolerance on +/- 3mm, as indicated on page 3.
Belt inserted in the
belt tightening block
Screw M6
Remove this to allow
putting the belt in the
belt tightening block
Direction to scroll the belt tightening block,
in order to tighten the belt