Re Revision II Plus Touch, Instructions For Installation, Use And Maintenance Manual, Page: 41 / 56

Re
S.p.A. ReVision II plus Touch
Rev. 21/05/13 38/51
COLOUR TYPE
To select the colours type you desire the system read during the Colour control function
RGB = the quantity of red, green and blue colours are shown on the screen
rgb = the normalized quantity of red, green and blue colours are shown on the screen
CYM = the quantity of cyan, yellow and magenta colours are shown on the screen
cym = the normalized quantity of cyan, yellow and magenta colours are shown on the screen
Advantage of normalized type is to maintain steady the read colour quantity, despite possible
changing of image brightness (caused by external environment light or by changing of iris); obviously if
the brightness change during taking of images is heavy, the quantity of colour read will not be steady,
but at least the difference will be limited.
Activating, changing and inactivating most of available functions, the Colour control function remains
active.
Activating the
Split function, the Colour control function can read the colour percentages of both the
current image, and the memorized image.
To deactivate this function press the on button at the bottom of the window in the colour format
function page.
ROTATE IMAGE
To rotate the image displayed on the screen in 90° steps.
Press the lock/unlock button to unlock the protected commands then press the rotate image button.
The image is rotated through 90° each time this button is pressed
FOCUS
To adjust the focus of the image.
Press the
lock/unlock button to unlock the protected commands then press one of the two focus
buttons to achieve the sharpest focus.
Warning!
Before proceeding with focusing you must enlarge the image to the maximum using the
zoom + button.
RAIL SETUP (only for motorized vision systems)
To set the software limit switch, between which the camera will move in autoscan state. Function useful
for limiting the camera stroke with the width of the laminate.
There are two limit switches and they must be one on the right and one on the left of the rail centre (the
reference is the magnet in the central zone of the rail). To set the limit switches, bring the camera in
Run