Re Revision II Plus Touch, Instructions For Installation, Use And Maintenance Manual, Page: 35 / 56

Re
S.p.A. ReVision II plus Touch
Rev. 21/05/13 32/51
Programmed scan
Programmed scan function (available only for LD and CV versions), this allows the viewing system to
take a determined sequence of images from the sheet prior to its being saved.
Below we describe the process for carrying out the programmed scan.

MEMORIZATION OF IMAGES: save the desired images as indicated on page 28.

SELECTING IMAGE SEQUENCE:
-
press image selection button in Run function mode and the screen will appear divided
into 9 sections with the saved images in the different print sections (do not consider the last
bottom right section which is for
image reconstruction ), select the working program where the
desired images are stored by pressing the numbered icons at the bottom of the screen;
-
press the images required; this will select the images to be scanned in the programmed scan
(the selected images are marked by a tick:

); obviously at least 2 images must be selected
to be able to activate this function;
-
if you press an image already selected this will deselect the image;
-
press exit and the system will exit the selected images screen.

ACTIVATE PROGRAMMED SCAN FUNCTION: press the lock/unlock button to activate the
protected commands.
Press the
autoscan type until the programmed autoscan button appears.
When the operator presses the autoscan button , the camera starts to acquire the print
images corresponding to the various selected sections in the correct order, maintaining the
individual focus and iris settings for each one.
This flag appears if the image has been
selected for the programmed scan
Exit