Re Revision II Plus Touch, Instructions For Installation, Use And Maintenance Manual, Page: 40 / 56

Re
S.p.A. ReVision II plus Touch
Rev. 21/05/13 37/51
AUTOSCAN TYPE
This function enables the operator to select the type of autoscan to be executed (the autoscan is
executed by pressing the
autoscan button).
Press the lock/unlock button to unlock the protected commands, then press the autoscan type button
to select the desired option. (Details on page 26).
horizontally autoscan
vertically autoscan
continuously autoscan
programmed scan
COLOUR CONTROL (only for MH , LD and CV vision systems)
Press the colour control button to display the corresponding menu on the right of the screen; this menu
can be used to select:
- the
spot dimensions
- the colour format
The colour format or the spot dimensions change each time the operator presses the corresponding
button.
To activate this function press the off button at the bottom of the screen.
To display the colour percentages, touch any point on the screen where there are no
icons present (excluding the colour control menu) twice in rapid succession. A window
like the one illustrated on the right appears in the bottom left corner of the monitor,
indicating the RGB or CYM colour percentage data for the point on the screen where
the cursor is positioned.
The colours percentages indicated, correspond to the average value of colours per
pixel.
The colours are indicated by the initial letter: R (red), G (green), B (blue), or C (cyan), Y (yellow), M
(magenta), written in capital letters for normal colour type, or in minuscule letters for normalized colour
type.
(To move the cursor, press the corresponding panel inside the window, then select the
desired part of the monitor)
SPOT DIMENSION
To select the dimension (in pixel) of the video point read by the Colour control function
4x4
8x8
16x16