Re Revision II Plus Touch, Instructions For Installation, Use And Maintenance Manual, Page: 9 / 56

Re
S.p.A. ReVision II plus Touch
Rev.21/05/13 6/51
4. Adjust the eccentrics if there is play between the camera and the rail: rotate the eccentrics with a 17
spanner (drawing 1) and tighten them with an Allen wrench (drawing 2).
Warning! The small wheels must not remain blocked but must be able to rotate freely.
Re
Revision Camera RH Revision Camera RH
Re
5. Place the toothed belt
a. Pass it at the rear of the camera and insert it in the gap between the right-hand small wheel and
the camera (drawing 1).
b. Pass it under the pulley.
c. Insert it in the gap between the left-hand small wheel and the camera (drawing 2).
Re
Revision Camera RH Revision Camera RH
Re
Pulley
Right-hand
small wheel
Right-hand
small wheel
Small wheels
Check that after adjusting the
eccentrics both small wheels
rotate freely
Eccentrics
Adjust both of them with a 17
spanner
Eccentrics
Tighten both of them with an
Allen wrench
Drawing 1 Drawing 2
Drawing 1 Drawing 2