Re Revision II Plus Touch, Instructions For Installation, Use And Maintenance Manual, Page: 44 / 56

Re
S.p.A. ReVision II plus Touch
Rev. 21/05/13 41/51
screen the previously acquired image for a longer period.
The greater the time that the same image is kept on the screen, the greater the details that can be
observed and assessed by the operator.
The duration of the lamps will be as great as the value set in this function.
Press the lock/unlock button to unlock the protected commands, then press the turns for flash button
(when it is active this icon is highlighted in green) and use the + and – buttons to select the desired
value.
The range of this value is
1 ÷ 100
Warning!
The camera will not, at any rate, acquire more than three images per second.
TEETH NUMBER
It is the number of jogs that the system waits for before acquiring the image. This parameter permits the
synchronisation of the image.
Press the lock/unlock button to unlock the protected commands, then press the teeth number button
(when it is active this icon is highlighted in green) and use the + and – buttons to select the desired
value.
The range of this value is
10 ÷ 9999
Warning!
If the value set is incorrect, the acquisition will not be synchronised with the print.
If you use the Encoder provided by Re S.p.A. and it is mounted so that the Encoder and the print
cylinder are coaxial, set
100 ; instead if the Encoder is not mounted on the same axis of the print
cylinder, the value you have to set depends on the possible transmission ratio between the Encoder
turns and the print development.
If the kind of Encoder used is different by the Re S.p.A Encoder, verify its number of pulses per turn
and select the correct value.
(The default setting is 100)
PRINT DEVELOPMENT (only for LD and CV vision systems)
To set the print cylinder circumference value, expressed in millimetres or inches, depending on the Unit
of length function setting (page 40).
Press the lock/unlock button to unlock the protected commands, then press the print development
button (when it is active this icon is highlighted in green) and use the + and – buttons to select the
desired value.
The range of this value in
mm is 100 ÷ 2000
The range of this value in inches is 4 ÷ 80