Re Revision II Plus Touch, Instructions For Installation, Use And Maintenance Manual, Page: 43 / 56

Re
S.p.A. ReVision II plus Touch
Rev. 21/05/13 40/51
INVERT VERTICAL ARROWS
To invert the functions of the vertical arrows to facilitate camera control.
Press the
lock/unlock button to unlock the protected commands. Each time the operator presses the
invert vertical arrows button the functions of the two vertical arrow functions are inverted.
UNIT OF LENGHT
To select the unit of measurement in which you want to set the print development value (see details
about the function on page 41) of the camera horizontal position.
Press the
lock/unlock button to unlock the protected commands, then press the unit of length button
to select the desired option.
mm = millimetres
inch = 1/4 of inches
AUTOSCAN SPEED (only for motorized vision systems)
Press this button to modify the speed at which the camera travels along the rail during the autoscan.
Press the
lock/unlock button to unlock the protected commands, then press the autoscan speed
button (when it is active this icon is highlighted in green) and use the + and – buttons to select the
desired value.
The range of this value is
1 ÷ 25
VERTICAL AUTOSCAN SPEED
Press this button to alter the speed at which the image moves during the vertical autoscan.
Press the lock/unlock button to unlock the protected commands, then press the vertical autoscan
speed button (when it is active this icon is highlighted in green) and use the + and – buttons to select
the desired value.
The range of this value is
-teeth number ÷ +teeth number
TURNS FOR FLASH
To set when to acquire the image in relation to the revolutions of the print cylinder: by setting this
parameter to 1, the camera will acquire one image at every complete revolution of the print roller
cylinder; setting this parameter to 10 will acquire one image every 10 revolutions, maintaining on the