Re Revision II Plus Touch, Instructions For Installation, Use And Maintenance Manual, Page: 31 / 56

Re
S.p.A. ReVision II plus Touch
Rev. 21/05/13 28/51
Memorization, loading and comparison of images
The camera is able to memorize one or more images (according to the viewing system version) and to
maintain it displayed on the screen contemporaneously as the image that is acquired each time. These
functions can be easily and immediately managed with the save (image memorization), goto (image
loading) and split (splitting the screen) buttons.
RF VERSION:
With this version of the viewing system you can save a single image to use to compare with the images
taken one at a time.
Press the save button in the Run (when there is an acquired frame on the screen) or Test functioning
modes to memorize the image on the screen.
Pressing the split button, divides the screen vertically, showing on the left hand side the image on the
sheet and on the right the memorized image, as shown below.
Pressing
split once again divides the screen horizontally showing in the top part the image on the sheet
and in the bottom part the memorized image.
Pressing split once again divides the screen vertically, showing on the left hand side the memorized
image and on the right hand side the image acquired from the sheet.
Pressing split once again the memorized image disappears from the screen, but it remains in the
memory even after switching off the system (when the system is switched on again the saved image
may be loaded using
go to button and then by pressing the split button you can view it to compare the
two images).
Memorized image
Image on belt
(continuously updated)
Split Save Goto