Re Revision II Plus Touch, Instructions For Installation, Use And Maintenance Manual, Page: 6 / 56

Re
S.p.A. ReVision II plus Touch
Rev.21/05/13 3/51
Assembling the ReVision II plus Touch on the end machine
The viewing system is usually supplied with the camera mounted on the motorized rail and the cams
already adjusted.
Therefore the installer only needs to fix the motorized rail to the machine in such a way that the distance
between the camera and the material is:
-
15mm ( ± 3mm ) for models RF , MH-75 or LD-75
- 10mm ( ± 3mm ) for models MH-100 , LD-100 or CV-350
Warning!
The indicated assembly distances can vary by +/- 3mm , therefore we recommend the
use of slots when fixing , so that the camera positioning can be adjusted until achieving optimal
focus
To assemble the viewing system wear safety gloves and boots and
observe all the safety norms required for the environment in which it
is installed.
ReVision MH-100, LD-100
ReVision RF, MH-75, LD-75
Fixing screws and slots
Fixing screws and slots
Material
Motorized rail
Earth cable connection :
To guarantee system operation in compliance with the EMC standards
to which it is subject, the rail must be connected to the machine earth.
This can be done using the fixing screws. Check that there is no paint
or other treatment which may isolate the rail from the machine
shoulder.
If in doubt, connect an earth wire directly to the point indicated by the
arrow: remove the M5 screw next to the channel, insert the earth cable
terminal between the two washers, then tighten the screw again. Use
the same method to fix the other terminal to the central screw of the
metal plate on the camera.
Material
Motorized rail