RaycoWylie i4000, Instruction Manual

Page: 33 / 72

33 i4000 Lattice Crane Instruction Manual
55M4000EBE00 Rev C
When the i4000 system is turned on, it runs a self-diagnostic during which it verifies the
communication between the CAN bus and the installed sensors. It than loads in its usage
memory (RAM) the information saved in its non-volatile (ROM) memory. During this stage,
the RaycoWylie logo appears on screen. When the test is completed and the live memory is
ready, the warning light turns green and the i4000 system is ready to be used.
If there is at least one jib activated on the i4000, the system will present the current configuration.
The crane operator must now confirm the configuration proposed by the system (by selecting
Yes), or choose another configuration (by selecting No).
Once he has chosen a configuration, the i4000 system switches to its normal operating mode.
If a limit has been set up and it has not been erased during the last session, the i4000 will then
display the following screen:
This tells the operator that a limit has been saved already and asks if it is still valid. This screen
will not appear if no limit is programmed into the system.
4.3 Power-up