Copyright © 1998 Rayco - All Rights Reserved
Printed in U.S.A.
RG 1672 DXH DIESEL SUPER CUTTER
TM
RAYCO
®
20
11. Test stump cutter tail lights for:
being lit when brakes are applied
being lit when headlights are on
getting brighter when brakes are applied
with headlights on
left light blinking when left turn signal is
on
right light blinking when right turn signal is
on
both lights flashing when emergency
flasher is on.
If any of above tests fail, troubleshoot
lighting system, and correct problem before
towing machine on public roadways.
Pre-Starting Inspection
NOTICE
To ensure the long life and economical operation
of your stump cutter, we highly recommend that
the operator be well instructed in both the opera-
tion and maintenance of this machine.
Inspect the machine and perform each of the 10
Service Hours or Daily (See
Maintenance
section)
maintenance inspections and services as found nec-
essary before operating the machine.
Starting the Engine
Understand and decide to heed the Safety
section of this manual, in its entirety, before
proceeding.
NOTICE
Do not operate the starter for more than 20 sec-
onds at a time. To do so may overheat the starter.
If the key switch is released before the engine
starts, wait until the starter and the engine stops
turning before trying again. This will prevent pos-
sible damage to the starter and/or flywheel.
If the engine does not start the first time, wait at
least 1 minute before trying again. If it does not
start after 2 attempts, see the Trouble Shooting
section of the
Deutz [Engine] Operation Manual.
Do not use the engine heating plug except when
operating in cold weather. Do not attempt to use
starting fluid to assist in the starting of the engine
when using heating plug.
If the temperature is below 32° F (0°C), use winter
grade diesel fuel. See the Operating Media
section of the
Deutz [Engine] Operation Manual
for details.
Use starting fluid only while simultaneously
cranking engine, and dispense only with an
apparatus approved by the engine manufacturer.
DO NOT start cutting wheel drive until
machine is in cutting position, next to stump!
Starting Without Heating Plug
1. Insert key into start switch.
2. Open engine speed control lever 1/4 of the
way.
O
PERATION
OFF
RUN
PREHEAT
START
Summary of Contents for SUPER CUTTER RG 1672 DXH DIESEL
Page 4: ......