Copyright © 1998 Rayco - All Rights Reserved
Printed in U.S.A.
17
RG 1672 DXH DIESEL SUPER CUTTER
TM
RAYCO
®
Machine Controls
(1) Cutting Wheel UP/DOWN Lever
Pull to raise cutting wheel. Push to lower
cutting wheel.
(2) Tongue IN/OUT Lever
Pull to retract cutting wheel in (away from
stump). Push to extend cutting wheel out
(toward stump).
(3) Cutting Wheel SWING Lever
Pull to move cutting wheel to the left. Push
to move cutting wheel to the right.
(4) Swing SPEED Control
Turning this valve counterclockwise will
decrease the cutting wheel cross travel
(LEFT/RIGHT motion) speed.
Turning the valve clockwise will increase the
cross travel speed.
NOTICE
WHEN TRANSPORTING, TURN THE VALVE
FULLY COUNTERCLOCKWISE TO CLOSE.
O
PERATION
A rotating cutting wheel is very
DANGEROUS! Stand at controls and ensure
that cutting wheel comes to a complete stop
before doing anything else.
(6) Engine SPEED Control
The engine SPEED control operates
similarly to the CUTTING WHEEL Drive
control. To increase engine speed, move
the engine speed control lever DOWN, until
desired speed is obtained. To decrease the
engine speed, move the engine speed
control lever UP until desired speed is
obtained.
(7) ENGINE START Switch
See the Starting the Engine section for
instructions on how to start engine.
1
3 4
2
7
6 5
(5) CUTTING WHEEL Drive Control
To start cutting wheel rotation move cutting
wheel drive lever downward to desired
speed. To increase or decrease speed
move lever toward desired symbol.
To stop CUTTING WHEEL drive
:
See the "Normal Shutdown Procedure"
section of this manual.
Summary of Contents for SUPER CUTTER RG 1672 DXH DIESEL
Page 4: ......