Copyright © 1998 Rayco - All Rights Reserved
Printed in U.S.A.
53
RG 1672 DXH DIESEL SUPER CUTTER
TM
RAYCO
®
M
AINTENANCE
I
NTERVALS
Every 6 Months or 6,000
Miles
Trailer Wheel Brake
Magnets
- Inspect
Detailed directions may be found in the
Trailer
Running Gear - Operation Maintenance Service
manual which was provided with the machine
.
Trailer Wheel Brake
Controller
- Check
Detailed directions may be found in the
Trailer
Running Gear - Operation Maintenance Service
manual which was provided with the machine
.
Trailer Wheels
- Inspect for
Cracks, Dents, Distortion
Detailed directions may be found in the
Trailer
Running Gear - Operation Maintenance Service
manual which was provided with the machine
.
Every 1
Year or 12,000
Miles
Trailer Wheel Bearings
-
Clean & Repack
Remove Hub
1. Elevate the side of the machine where the
wheel is being inspected. A common hydraulic
floor jack may be used.
Position lifting arm of such jack directly under
nearside end of machine chassis cross-
member. Support the raised side of machine
with a solid wooden block or standard jack
stand, positioned directly under nearside end of
machine chassis cross-member.
Referring to the WHEEL ASSEMBLY in the Parts
section...
2. Remove the wheel (15).
3. Remove the dust cap (14) by carefully prying
progressively around the flange of the cap.
4. Remove the cotter pin (13) from the castle nut
(12).
5. Unscrew the castle nut (counter-clockwise) and
remove the spindle washer.
6. Remove the hub (8) from the spindle, being
careful not to allow the smaller bearing race &
rollers (cone) (10) to fall out. The larger bearing
race & rollers (cone) (6) will be retained by the
seal (5).
Summary of Contents for SUPER CUTTER RG 1672 DXH DIESEL
Page 4: ......