Copyright © 1998 Rayco - All Rights Reserved
Printed in U.S.A.
23
RG 1672 DXH DIESEL SUPER CUTTER
TM
RAYCO
®
Removing Stumps
Before operating, please carefully review the
Safety section for vital information related to op-
erating this powerful machine!
NOTICE
Remove all loose pieces of wood, stones, wire and
other debris from the work area before beginning
stump removal.
Wind direction should be considered, as it influ-
ences the direction that dust and wood chips will
be directed.
Always allow a cold engine time to warm up before
cutting a stump.
When swinging cutting wheel, do not use the
cutting wheel or boom to stop the swinging mo-
tion. Inspect the machine for damage if the boom
has been swung hard into the stump or side of
hole.
Whenever the tires of the machine raise off the
ground while operating, lower the machine back
to the ground smoothly. DO NOT DROP OR CATCH
IT SUDDENLY WITH THE HYDRAULICS. Damage to
the machine can result.
O
PERATION
Only the portion of cutting wheel within the
80° area shown above should engage
stump. Never undercut the stump or use
the bottom of the cutting wheel for cutting
purposes.
Procedure for Cutting a Stump
Never leave controls when cutting wheel is
rotating!
1.
Prepare machine at stump
Back machine into position with cutting wheel
near top edge of stump.
Secure towing vehicle so that it will hold machine
firmly while cutting stump. This may include
putting transmission in PARK, setting emergency
brake, even blocking wheels, depending on the
towing vehicle in use and the conditions of the
work-site.
Summary of Contents for SUPER CUTTER RG 1672 DXH DIESEL
Page 4: ......