Machine adjustments
43
7
7.2
Adjusting the spreading disc or agitator speed
7.2.1
PTO drive
The speeds for spreading disc and agitator are given in the spreading table.
7.2.2
Hydraulic motor drive
On spreaders with hydraulic drive, the speed is set using the flow control valve.
The values to be set can be taken from the following table.
Adjustment values for 100 cm
3
hydraulic motor
NOTICE
If adjusting the drop point is not sufficient for obtaining a symmetric spreading
pattern, the vanes on the spreading disc can also be adjusted. See
7.6.3: Adjusting the spreading vanes, page 52
.
NOTICE
With narrower working widths and with good quality of the spreading material,
the agitator speed can also be reduced.
NOTICE
If adjusting the drop point is not sufficient for obtaining a symmetric spreading
pattern, the vanes on the spreading disc can also be adjusted. See
7.6.3: Adjusting the spreading vanes, page 52
.
n
CAUTION
Possible spreading error and material damage.
Incorrectly adjusted spreading disc or agitator speeds can lead to
increased wear or spreading errors.
The speed for the specific spreader material can be taken
from the spreading table.
n
CAUTION
Possible spreading error.
Excessively high spreading disc and agitator speeds can lead to
increased mechanical loads in the spreading material that can
lead to spreading errors.
The speed for the specific spreader material can be taken
from the spreading table.
Summary of Contents for 2.1
Page 30: ...Machine data 4 24...
Page 32: ...Transport without tractor 5 26...
Page 108: ...Service and maintenance 9 102...